Behringer SRC2000 Instrukcja Użytkownika Pobierz pdf (Strona 17)

4.1.3 Output Section

21 22 23 24

Fig. 4.4: Controls of the Output Section

SYNC Switch. Pressing this switch allows you to synchronize the ULTRAMATCH from an external

source connected to the wordclock input on the rear panel.

SAMPLE FREQ Switch. Set the output sample rate to 44.1 kHz or 32 kHz with this switch.

+ If the mode EXTERN SYNC has been selected, set this switch to the sample rate of the wordclock

signal to assign the correct sample rate information (32 kHz or 44.1 kHz) to the output signal!

The audio signal will be sent to the output with the sample frequency of the external wordclock

signal, but the sample frequency bit (see 1.2) is set to the position of the SAMPLE FREQ

switch.

EMPHASIS Switch. Use this switch to select, whether the emphasis information received at the input is

transmitted to the output (AUTO), or if the emphasis is always switched off at the output (NO EMPHA-

SIS).

FORMAT Switch. Use this switch to select the output format of the ULTRAMATCH defined in the

channel status data. You can choose either AES/EBU or SPDIF.

4.2 Rear Panel

25 28 29 27 26

Fig. 4.5: Controls on the ULTRAMATCHs Rear Panel

MAINS CONNECTOR and FUSE HOLDER/VOLTAGE SELECTOR. Please use the enclosed mains

cable to connect the unit to the mains power supply. Please take a look at the chapter INSTALLATION

for further information. For replacing the safety fuse, always use the same type.

Serial Number. Put the instruction manual in a safe place and return the completed warranty registra-

tion card to us within 14 days of purchase, making sure that the dealer stamp has been acquired.

INPUTS. These are the three inputs of the ULTRAMATCH.

OUTPUTS. These are the three outputs of the ULTRAMATCH.

EXT SYNC IN. Connect an external wordclock source to this BNC socket for synchronization pur-

poses.

4. CONTROLS AND FUNCTIONS

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 23 24 25

Brak uwag

Behringer SRC2000 Instrukcja Użytkownika Strona 17